Cyprus Broadband Forum

I am currently running my own router on my internet line. A Draytek 2800VG as its a good VoIP router.

I am looking to get MiVision, is there any settings i need to change, other than connect the set top box to a spare ethernet port. And wait for my line to re-sync at 3 or 4 Mbit?

Do I need to forward any ports? Is there any change to the VPC settings on the ATM side of things??

Hello,

Mivision is usually connected directly on the modem provided by Cyta, and not on the router. Are you using the Draytek only as a router, or you are using it an ADSL modem as well, replacing the modem provided by Cyta with it?

Cyta provide a Speedtouch 585v6. This is a 4 port modem/router/switch.

I have replaced it with the draytek, so I have directly replaced the speedtouch with a draytek.

Hello,

I am not sure how exactly that would work.

I tried to connect Amino on my router instead of the modem provided by Cyta but it didn't work correctly. The EPG was working but no image or sound was coming.

I am guessing that there should be a way to make it work. It may even work straight away for you. Unfortunately I can not know for sure, or how.

You have to setup extra ATM settings. If you understand how to configure multiple VPI/VCI them i have the document from a cyta tech listing the correct settings to get ANY router working.

Hello,

Personally I do not need this as I am using the modem provided by Cyta.

However it would be nice if you could attach this document in a post in case somebody else will need this information in the future.

Thank you

Attached is the setting required fopr amy Multi PVC router to run MiVision.